We have compiled a list of manufacturers, distributors, product information, reference prices, and rankings for Loop antenna.
ipros is IPROS GMS ・ IPROS One of the largest technical database sites in Japan that collects information on.

Loop antenna - List of Manufacturers, Suppliers, Companies and Products | IPROS GMS

Loop antenna Product List

1～5 item / All 5 items

Displayed results
Loop antenna passive 9kHz to 30MHz

Loop antenna passive 9kHz to 30MHz

Designed for radiated emission measurements in the frequency range of 9 kHz to 30 MHz in accordance with CISPR 16.

The loop antenna TBMA6-P is designed for measuring radiated emissions in the frequency range of 9 kHz to 30 MHz in accordance with CISPR 16. The diameter of the loop is 60 cm, providing sufficient sensitivity to perform all relevant measurements specified in the corresponding CISPR standards for the frequency range of 9 kHz to 30 MHz. The loop is constructed from coaxial cable and is attached to the transducer with an N connector. This design allows for flexible use with various loop diameters. An attachment with a ¼-inch screw allows it to be connected to a standard tripod.

  • Time-frequency measurements
  • Other electronic measuring instruments
  • Other measurement, recording and measuring instruments
  • Loop antenna

Added to bookmarks

Bookmarks list

Bookmark has been removed

Bookmarks list

You can't add any more bookmarks

By registering as a member, you can increase the number of bookmarks you can save and organize them with labels.

Free membership registration
RE101 Loop Antenna 30Hz–100KHz

RE101 Loop Antenna 30Hz–100KHz

RE101 Loop Antenna TBRE101 30 Hz to 100 kHz

The TBRE101 is a passive receiving loop antenna used in the MIL-STD-461G RE101 test. It is employed to measure radiated emissions from electronic equipment and subsystems, including electrical cable interfaces for defense applications. The TBRE101 is used to measure low-frequency magnetic field emissions at a position 7 cm around the device under test (DUT). The test frequency range is from 30 Hz to 100 kHz. The test setup and measurement procedures are specified in Section 5.17 of MIL-STD-461G. The TBRE101 consists of a coil with a diameter of 13.3 cm, wound 36 times with seven strands of 41 AWG litz wire inside a shield. The DC resistance of the loop winding is 10Ω. This loop receives magnetic field radiation that is perpendicular to the internal plane and generates a voltage signal at the loop's output port that is proportional to the intensity of the B field/H field radiation. As a calibration option accessory, the TekBox TBCCP1-2K70 coaxial RF current monitoring probe (transducer) is available, which has a flat transfer impedance of 0 dBΩ (1V/A) over a frequency range of 9 kHz to 30 MHz at a 50Ω load.

  • Other measurement, recording and measuring instruments
  • EMC Testing
  • Loop antenna

Added to bookmarks

Bookmarks list

Bookmark has been removed

Bookmarks list

You can't add any more bookmarks

By registering as a member, you can increase the number of bookmarks you can save and organize them with labels.

Free membership registration
EMC Antenna Schwarzbeck Loop Antenna

EMC Antenna Schwarzbeck Loop Antenna

EMC (EMI/EMS), loop antenna compatible with antenna measurements! Supported frequency range is DC to 400MHz.

We would like to introduce the "Schwarzbeck Loop Antenna and Helmholtz Coil" that we handle. We offer an "Active Loop Antenna" with a frequency range of 9 kHz to 400 MHz, as well as an "RX Loop Antenna" with a frequency range of 9 kHz to 300 MHz. Additionally, we have a "Helmholtz Coil" designed to accurately generate magnetic fields from DC to frequencies exceeding the audible range. 【Features】 ■ Type: Loop Antenna ■ Frequency Range: DC to 400 MHz *For more details, please refer to the related links or feel free to contact us.

  • antenna
  • Loop antenna

Added to bookmarks

Bookmarks list

Bookmark has been removed

Bookmarks list

You can't add any more bookmarks

By registering as a member, you can increase the number of bookmarks you can save and organize them with labels.

Free membership registration
Simple Low-Frequency Radiation System

Simple Low-Frequency Radiation System

[Application Example] Construction of a Low-Frequency Radiation System at Low Cost

【Product Introduction】 ■Loop Antenna MAN120 A compact loop antenna with a diameter of 40 cm, suitable for measuring low frequencies. By limiting frequency and radiation levels, it is possible to construct a radiation system in the low frequency range at a low cost. It is effective when existing equipment cannot cover the low frequency range or when there is a need to easily conduct radiation in a limited low frequency range. Additionally, it can be used in combination with our company's anechoic chamber lineup.

  • Other electronic measuring instruments
  • Loop antenna

Added to bookmarks

Bookmarks list

Bookmark has been removed

Bookmarks list

You can't add any more bookmarks

By registering as a member, you can increase the number of bookmarks you can save and organize them with labels.

Free membership registration
Loop antenna 9kHz–30MHz TBLLA-2M

Loop antenna 9kHz–30MHz TBLLA-2M

Loop antenna 9kHz–30MHz TBLLA-2M

The TBLLA-2M is a large loop antenna (LLA) equipped with three orthogonal loops that meets the requirements of CISPR 16-1-4 and CISPR 15/EN 55015. The LLA is used to measure the current induced by the magnetic field radiated from lighting fixtures. Section 4.4 of EN 55015 specifies the test setup and measurement procedures. The TBLLA-2M has three loop antennas with a diameter of 2 meters arranged vertically on three orthogonal planes (X/Y/Z). These antennas are mounted on a lightweight hollow WPC frame with a total height of 2.5 meters. The lowest point of the loops is 0.5 meters above the ground. Each loop element receives a magnetic field radiation that is perpendicular to the installation surface, generating a voltage signal at the output port of the RF transducer connected to the loop, which is proportional to the strength of the H magnetic field radiation. The TBLLA-2M is equipped with three TekBox TBCCP1-2K70 coaxial RF current monitoring probes (transducers). These probes have a flat transfer impedance characteristic of 0dBΩ (1V/A) over a frequency range of 9kHz to 30MHz at a 50Ω load.

  • EMC Testing
  • Loop antenna

Added to bookmarks

Bookmarks list

Bookmark has been removed

Bookmarks list

You can't add any more bookmarks

By registering as a member, you can increase the number of bookmarks you can save and organize them with labels.

Free membership registration

Related Categories of Loop antenna

COPYRIGHT © 2001-2026 IPROS CORPORATION ALL RIGHTS RESERVED.